626 ES V6-2.5L DOHC (1997)
NOTE:
For foam padding installation refer to model application shown.
1.
Remove the blower motor and clean all debris from the area.
WARNING:
BE CAREFUL NOT TO CUT YOURSELF WHEN REMOVING THE DEBRIS FROM THE BLOWER CASE.
2.
Remove debris, if any, from around the blower unit inlet (Fresh air & Air Recirculation).
A.
PROTEGE
1.
Remove the cowl grille and check for the foam padding installed at the back of the cowl grille on the passenger-side.
^
If no packing is found, add one in the position shown in Fig. 2.
