626 ES V6-2.5L DOHC (1997)
ABS Main Relay: Testing and Inspection
Fail-Safe Relay Harness
1. Turn the ignition switch OFF and disconnect the ABS control module connector (18 pin).
2. Turn the ignition switch ON.
3. Connect terminal 2J of the control module connector (18 pin) to a ground.
4. Check the following points:
^
If the fail-safe relay in ABS relay does not click when terminal 2J is grounded.
-
Check fail-safe relay
-
Check harness between fail safe relay and ABS control module.
^
If Warning light illuminates after grounding terminal 2J.
-
Check fail-safe relay.
^
If terminal 1D of ABS control module connector does not indicate 12V.
-
Check fail-safe relay.
-
Check harness between fail safe relay and ABS hydraulic unit.
