626 ES V6-2.5L DOHC (1997)
Alignment: Service and Repair
Rear Wheel Alignment
TOTAL TOE-IN
The thrust angle can only be measured with 4-wheel alignment tester. If the thrust angle is not within -0.2° to +0.8, check the body dimensions.
1. Remove the access hole caps.
2. Loosen the cam nut on the lateral link.
3. Turn the adjusting cam bolt as indicated to adjust the toe-in. For the left wheel toe-out is counterclockwise and toe-in is clockwise. For the
right wheel toe-out is clockwise and toe-in is counterclockwise.
NOTE: Turning the adjusting cam bolt one graduation changes the toe-in about 3.2 mm (0.13 inch) (0.30°).