626 ES V6-2.5L DOHC (1997)
Boot
1. Wrap the shaft splines with tape to protect the boot.
2. Remove the boot.
ABS sensor rotor
NOTE: The sensor rotor does not need to be removed unless you are replacing it.
1. Tap the ABS sensor rotor off the drive shaft with a chisel.
2. Inspect all parts and repair or replace as necessary.
ASSEMBLY
1. Verify that all parts are free of dust, dirt and other foreign material immediately before reassembly.
2. Assemble in the reverse order of disassembly, referring to the following steps.
ABS sensor rotor
Set a new ABS sensor rotor on the drive shaft in the direction as shown, and press it onto the shaft assembly by using the SST.
Boot
1. Wrap the shaft splines with tape.