626 ES V6-2.5L DOHC (1997)
Oil seal (differential)
1. Using the Special Service Tool (SST) and a hammer, tap the new differential oil seal in evenly until the SST contacts the transaxle case.
2. Coat the lip of the oil seal with transaxle oil.
Bearing race (differential)
1. Install the adjustment shim(s) to the differential case.
2. Apply transaxle oil to the differential bearing race, and install it to the differential case by using a pipe.
Bearing race (transaxle case)
1. Install the adjustment shim(s) to the primary and secondary shaft bearing seats in the transaxle case.
2. Apply transaxle oil to each transaxle case bearing race, and install them to the transaxle case by using a pipe.
Oil seal (change rod assembly)
1. Install the new change rod assembly oil seal by using a pipe.
2. Coat the lip of the oil seal with transaxle oil. Outer diameter of pipe should be 26.0 mm (1.02 inch).
