626 ES V6-2.5L DOHC (1997)
3rd Gear, 3rd Synchronizer Ring, And 3rd/4th Clutch Hub Assembly
^
Install the 3rd gear, 3rd synchronizer ring, and 3rd/4th clutch hub assembly by using a press.
4th Synchronizer Ring, 4th Gear, And Bearing
1. Install the 4th synchronizer ring, 4th gear, and a new bearing by using the SSTs.
2. Measure the clearance between the 3rd gear and 2nd gear. Clearance should be within 0.05 - 0.20 mm (0.002 - 0.008 inch) and the maximum
is 0.25 mm (0.010 inch).
3. Measure the clearance between the 4th gear and bearing. Clearance should be within 0.17 - 0.37 mm (0.007 - 0.015 inch) and the maximum is
0.42 mm (0.017 inch).
4. If not as specified, reassemble the primary shaft assembly.