626 LX L4-2.0L DOHC (1999)
4.
Remove the sunroof motor and align the motor per as shown. a 4 mm hex wrench can be used to line up the pointers if they are slightly
mis-aligned.
NOTE:
Do not reinstall the motor at this time.
5.
Verify that both left and right front sunroof guides are properly clipped onto their respective drive cables.
6.
Align the left and right drive cables to front guides by gently moving the drive cable(s) until the alignment holes are centered.
CAUTION:
Do not push on the guides themselves or breakage may occur.
NOTE:
A mirror can be used to better judge the alignment hole centering.
7.
Insert a 3 mm pin or equivalent tool into each alignment hole. Refer to illustration.
8.
Reinstall the motor per the Workshop Manual (SUNROOF MOTOR INSTALLATION).
9.
Remove the alignment pins/tools from both sides.
CAUTION:
Failure to remove alignment tools could result in severe damage to the sunroof guides and components.
10.
Turn ignition key on.
