626 LX L4-2.0L DOHC (1999)
Air Door Actuator / Motor: Service and Repair
Airflow Mode Main Link
AIRFLOW MODE MAIN LINK REMOVAL/INSTALLATION
1. Disconnect the negative battery cable.
2. Remove the airflow mode actuator.
3. Remove in the order indicated in the table.
4. Install in the reverse order of removal.
Airflow Mode Main Link Installation Note
CAUTION: If any grease other than the specified grease is applied to the links, abnormal noise will occur or the links will not properly operate.
Therefore, do not apply any grease to the links.
1. Push and hold each airflow mode sub link in the direction of the arrow.
2. Set the airflow mode main link to the heater unit as shown in the figure.