626 LX L4-2.0L DOHC (1999)
-
Tap the ABS sensor rotor off the drive shaft by using a chisel.
ABS Sensor Rotor (With ABS) Assembly Note
CAUTION: Verify the direction of the sensor rotor.
-
Set a new ABS sensor rotor on the drive shaft and press it on by using the SST.
Boot Assembly Note
NOTE:
-
The wheel side and transaxle side boots are different.
-
Use the specified grease supplied in the boot kit.
1. Fill the boot (wheel side) with the specified grease.
2. With the splines of the shaft still wrapped in tape from disassembly, install the boot.
3. Remove the tape.
Dynamic Damper (FS engine) Assembly Note
