626 LX V6-2.5L DOHC (1997)
Step 1
1. Remove the hazard warning switch.
2. Check for continuity between terminal B (B) of the hazard warning switch connector and ground.
Terminal Identification
Reference
Step 2
1. Check for continuity between the terminals of the hazard warning switch.
2. If correct, reconnect the connector and go to Step 3.
3. If not as specified, replace the hazard warning switch.
Ohmmeter Connection
Action Chart
Step 3
1. Turn the hazard warning switch on.
2. Check for continuity between terminal G (G/R) of the flasher unit connector and ground.
Pinpoint Test 4
Flowchart No.4 Symptom Left or right turn signal function does not operate (hazard light function operates)
Possible Cause
^
Damaged combination switch
^
Damaged flasher unit
^
Open or short circuit in wiring harness Poor connection of connector
Terminal Identification