626 LX V6-2.5L DOHC (1997)
Transaxle Range Switch: Service and Repair
With Automatic Transaxle
REPLACEMENT
1. Disconnect the negative battery cable.
2. Remove the resonance chamber, fresh-air duct, and air cleaner assembly.
3. Disconnect the transaxle range switch connector.
4. Remove the clip.
5. Remove the selector cable in the order shown in the figure.
(1) Disconnect the selector cable from the manual shaft lever.
(2) Pull out the selector cable from the cable bracket and remove it.
6. Remove the manual shaft nut.
7. Remove the lock-washer and lever.
8. Remove the transaxle range switch.
9. Rotate the manual shaft to N position.
10. Turn the transaxle range switch so that the neutral mark is in line with the flat, straight surfaces on either side of the manual shaft.
11. Hand tighten the transaxle range switch bolts.
12. Verify that there is continuity between terminals A and H of the transaxle range switch connector.
13. Tighten the transaxle range switch mounting bolts.