626 LX V6-2.5L DOHC (1997)
Selector Lever
1. Install the selector lever and tighten to 16 - 22 Nm (12 - 16 ft. lbs.).
2. Install the selector cable to the selector lever.
3. Push the selector lever adjust P position.
4. Connect the set button.
5. Slide the lock cover and lock the set button.
6. Install the interlock cable to the selector lever and tighten to 10 - 15 Nm (87 - 130 inch lbs.).
Indicator Panel
1. Shift the selector lever to P position.
2. Align the alignment screws in the slider with the holes in the indicator panel. Install heavy-gauge wire to hold the slider.
3. Tighten the indicator panel screws in the order shown in the illustration to 2.0 - 2.9 Nm (18 - 26 inch lbs.).
4. Remove the wire.
5. Verify that the selector lever properly aligns with the indicator in each range.
AFTER INSTALLATION
^
Check the shift-lock, emergency override button, and key interlock operations.
