626 LX V6-2.5L DOHC (1997)
16. Install the rubber ball into the front control valve body.
17. Set a new front/premain rear gasket, premain separator plate, and new front/premain front gasket on the front control valve body. Refer to the
illustration to distinguish the two gaskets.
18. Set the front control valve body onto the premain control valve body.
19. Install and hand tighten the bolts shown. Each type of bolt has a different letter on its head. Match the bolt letter with the letter stamped next to its
installation hole on the valve body. Refer to illustration for bolt installation position and description.
20. Install four control valve body bolts as shown for alignment.
21. Tighten the mounting bolts.
a. Tighten the front control body bolts to 6.5 - 7.8 Nm (58 - 69 inch lbs.).
