929 V6-3.0L DOHC (1993)
^
Remove yellow cap from female connector by prying alternately on each side.
^
Pry terminal internal locks upward and remove terminals.
6.
Strip insulator (enough for splicing) from all harnesses (including intermediate).
7.
Splice, solder and tape color coded wires of the intermediate harness into the actuator and vehicle harnesses. Refer to Fig. 3
NOTE:
Stagger the connections between the vehicle harness and the intermediate harness as shown. Stagger the connections between the actuator and
the intermediate harness as much as possible.
8.
Wrap loose wires with tape on both vehicle and actuator sides. Tape should cover all splicing and merge with vehicle harness.
9.
Install rear door trim.
10.
Connect negative battery terminal and reset audio stations and clock.