929 V6-3.0L DOHC (1993)
3.
Remove the bolts and washers fastening the positioning plate, front guide and rear guide to the sunroof assembly. Refer to Fig. 1.
NOTE:
Washers must be re-used when installing the new bolt. Take precautions not to damage or lose the washers.
4.
Lift the position plate and remove any grease from the areas indicated in Fig. 2.
5.
Attach the pads to the areas indicated in Fig. 2.
6.
Apply adhesive (super glue or equivalent) to the areas of the pad shown. Refer to Fig. 2.
NOTE:
Although the pads have an adhesive backing, it is important to attach the pads with additional adhesive to prevent pad movement.
7.
Install the position plates using new bolts and the washers which were removed in step 3.
8.
Install the steel or solar panel and adjust the gap according to the instructions in section S of the workshop manual.
NOTE:
Vehicles with a solar panel - Confirm that the wiring for the solar panel does not interfere with the sunroof drive mechanism (position plates
etc.)
9.
Confirm repair.
