929 V6-3.0L DOHC (1993)
RH Camshaft Cap Bolt Tightening Sequence
LH Camshaft Cap Bolt Tightening Sequence
8. Tighten the left cylinder head camshaft cap bolts gradually in the order shown.
Tightening torque:
29.0-31.8 Nm (2.95-3.25 kgf m, 21.4-23.5 ft. lbf.)
9. Tighten bolts A of the left cylinder head.
Tightening torque:
7.9-10.7 Nm (80-110 kgf cm, 70-95.4 in. lbf.)
10. Apply clean engine oil to the lip of each new camshaft oil seal.
11. Push the oil seal in slightly by hand.
12. Using a pipe and hammer, tap the oil seal in evenly until it is flush with the edge of the camshaft cap.
Note
^
Oil seal outer diameter: 51.0mm (2.01 in) (RH) 81.0mm (3.19 in) (LH)
^
Oil seal inner diameter: 38.5mm (1.52 in) (RH) 65.5mm (2.58 in) (LH)
Camshaft pulley
Hold the camshafts by using a wrench on the cast hexagon as shown, and tighten the bolts.
Tightening torque:
RH: 71-80 Nm (7.2-8.2 kgf m, 53-59 ft. lbf.)
LH: 19-25 Nm (1.9-2.6 kgf m, 14-18 ft. lbf.)
