929 V6-3.0L DOHC (1993)
Ignition Cable: Testing and Inspection
High Tension Lead Resistance Check
Cylinder Numbering
1.
Carefully check wires from end to end for cracked or burned insulation, damaged or loose terminals, swelling from contact with oil or any other
obvious problems. Replace wires as required.
2.
Check each wire for resistance. Replace wires with excessive resistance.
Average 16K ohms per 3.28 feet (1 meter)
NOTE: If replacement is indicated for one or more ignition wires, it is good practice to replace the entire set. Always route wires carefully, away from
hot exhaust system surfaces and electronic components.