929 V6-3.0L DOHC (1993)
2. Check knuckle spindle for cracks or damage, and oil seal friction surface for wear or rust, replace as required.
3. Check knuckle and knuckle arm for damage, replacing as necessary.
4. Check dust cover and hub cap for damage, replacing as necessary.
Assemble
Hub Bolt
Press in new hub bolts.
Sensor Rotor
Press on the new sensor rotor by using the SST.
Installation
1. Install knuckle arm and tighten nut to specifications, then install new cotter pin.
2. Install knuckle spindle to shock absorber, tighten bolts to specifications.
3. Install knuckle arm to tie rod end, tighten nut to specifications.
4. Install knuckle arm to knuckle spindle, tighten bolt to specifications.
5. Install dust cover, tighten bolts to specifications.
6. Install disc plate, tighten nut to specification, ensure endplay does not exceed 0.002 inch (0.05 mm).
7. Stake locknut to groove and install hub cap, Fig. 2.
Fig. 2 Front Hub Nut Stake Location
8. Install wheel speed sensor, tighten bolt to specifications.
9. Install caliper assembly, tighten bolts to specifications.
10. Install wheel and tighten lug nuts to specifications.