929 V6-3.0L SOHC (1989)
Steering Angle Sensor: Testing and Inspection
Fig. 7 AAS Control Unit Terminals A, C And D
Fig. 8 Steering Wheel Test Positions
Fig. 9 Angle Sensor Circuit Test Chart
CIRCUIT
1.
Remove rear seat and the control unit cover.
2.
Disconnect AAS control unit connectors, then turn ignition switch to On position.
3.
Check resistance of terminals, Fig. 7, while turning steering wheel, Fig. 8, as shown in test chart, Fig. 9.
4.
If resistances are not as specified, check the angle sensor and wiring harness.
Fig. 10 Angle Sensor Terminal Identification