B2300 L4-2.3L (2008)
Hydraulic Control Assembly - Antilock Brakes: Service and Repair
HYDRAULIC CONTROL UNIT (HCU)
Removal and Installation
Warning:
^
Use of any other than approved DOT 3 brake fluid will cause permanent damage to brake components and will render the brakes
inoperative. Failure to follow these instructions may result in personal injury.
Warning:
^
Brake fluid contains polyglycol ethers and polyglycols. Avoid contact with eyes. Wash hands thoroughly after handling. If brake fluid
contacts eyes, flush eyes with running water for 15 minutes. Get medical attention if irritation persists. If taken internally, drink water
and induce vomiting. Get medical attention immediately. Failure to follow these instructions may result in personal injury.
Caution:
^
Brake fluid is harmful to painted and plastic surfaces. If brake fluid is spilled onto a painted or plastic surface, immediately wash it with
water.
1. Disconnect the negative battery cable.
2. Disconnect the anti-lock brake system (ABS) module electrical connector by rotating the release lever.
Note:
