B2300 L4-2.3L (2008)
Brake Bleeding: Service and Repair
Four Wheel Anti-Lock Brake System (4WABS) Hydraulic Control Unit (HCU)
Four Wheel Anti-Lock Brake System (4WABS) Hydraulic Control Unit (HCU)
Note:
^
Only carry out this procedure if a new HCU has been installed.
1. Clean all dirt from and remove the brake master cylinder filler cap, and fill the brake master cylinder reservoir with clean, specified brake fluid.
2. Connect a clear drain tube to the RH rear bleeder screw and the other end in a container partially filled with clean, specified brake fluid.
3. Have an assistant pump the brake pedal and then hold firm pressure on the brake pedal.
4. Loosen the RH rear bleeder screw until a stream of brake fluid comes out. While the assistant maintains pressure on the brake pedal, tighten the
bleeder screw.
^
Repeat until dear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
5. Tighten the bleeder screw.
^
Tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).
6. Repeat Steps 3-5 for the LH rear bleeder screw, the RH front bleeder screw and the LH front bleeder screw, in that order.
