B2300 L4-2.3L (2008)
5. Tighten the RH rear bleeder screw.
^
Tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).
6. Repeat Steps 2-5 for the LH rear bleeder screw.
7. Place a box end wrench on the RH front disc brake caliper bleeder screw. Attach a rubber drain tube to the RH front disc brake caliper bleeder
screw, and submerge the free end of the tube in a container partially filled with clean brake fluid.
8. Have an assistant pump, and then hold firm pressure on, the brake pedal.
9. Loosen the RH front disc brake caliper bleeder screw until a stream of brake fluid comes out. While an assistant maintains pressure on the brake
pedal, tighten the RH front disc brake caliper bleeder screw.
^
Repeat until dear, bubble-free fluid comes out.
^
Refill the brake master cylinder reservoir as necessary.
10. Tighten the RH front disc brake caliper bleeder screw.
^
Tighten to 15 N-m (1.5 kgf-m, 11 ft-lbf).
11. Repeat Steps 7-10 for the LH front disc brake caliper bleeder screw.