B2300 L4-2.3L (2008)
Caution:
^
Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor locking clip may occur.
2. Using a pocket screwdriver, or similar tool, remove the sensor locking clip. cradle and pushing the opposite end of the sensor down onto the
cradle.
Caution:
^
Do not use a large screwdriver. Apply minimum force during removal or damage to the sensor may occur.
3. Using a pocket screwdriver, or similar tool, detach the sensor from the cradle.
4. Remove the sensor.
Assembly Note
Caution:
^
Damage to the sensor can occur if excessive force is applied during sensor installation.
Note:
^
Make sure the sensor is fully seated into the cradle. The sensor will make a "click" noise when correctly seated.
1. Position the sensor into the cradle by inserting the hinge end of the sensor into the hook end of the cradle and pushing the opposite end of the
sensor down onto the cradle.
