B2300 L4-2.3L (2008)
Evaporative Canister Filter: Service and Repair
DUST SEPARATOR REMOVAL / INSTALLATION
1. Remove the evaporative emission (EVAP) canister.
2. Disconnect the canister vent solenoid hose assembly.
3. Remove the EVAP dust separator.
4. To install, reverse the removal procedure.
-
Perform Leak Test. See EVAPORATIVE EMISSION SYSTEM LEAK TEST. See: Leak Detector/Testing and Inspection
-
Perform the Evaporative Emission Running Loss Monitor Repair Verification Drive Cycle Test. See DRIVE CYCLES. See: Computers and
Control Systems/Testing and Inspection/Monitors, Trips, Drive Cycles and Readiness Codes/Driver Cycles
