B2300 L4-2.3L (2008)
PROM - Programmable Read Only Memory: Customer Interest
Engine Controls - Cold Start High Idle Speed
Bulletin No: 01-007/10
Last Issued: 01/15/2010
Subject:
HIGH IDLE AT COLD START OR DEPRESSING CLUTCH
BULLETIN NOTE
APPLICABLE MODEL(S)/VINS
DESCRIPTION
Customers having this concern should have their vehicle repaired using the following repair procedure.
REPAIR PROCEDURE
(Use Steps below for all models)
1. Reboot the IDS to clear memory before reprogramming.
2.
NOTE:
^
This bulletin does not apply to California Spec. vehicles.
^
Always update the IDS tool first, then follow on-screen instructions to download the needed calibration file for PCM reprogramming.
^
It is not necessary to remove any fuses or relays during PCM reprogramming when the IDS screen prompts you to do so. You may
accidentally stop power to one of the PCM terminals and cause the PCM to be blanked, or you may receive error messages during the IDS
reprogramming procedure.
^
IDS shows the calibration part numbers after programming the PCM.
^
Please be aware that PCM calibration part numbers and file names listed in any Service Bulletin may change due to future releases of IDS
software, and additional revisions made to those calibrations for service related concerns.
^
When reprogramming a PCM, IDS will always display the latest" calibration P/N available for that vehicle. If any calibration has been
revised/updated to contain new information for a new service concern/issue, it will also contain all previously released calibrations.
