B2300 L4-2.3L (2008)
operation and does not indicate a supplemental restraint system (SRS) fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
A repair is made by installing a new part only. If the new part does not correct the condition, install the original part and perform the diagnostic
procedure again.
All vehicles
1. Depower the SRS. See DEPOWERING AND REPOWERING.
Vehicles equipped with 2.3L and A/C
2. For the RH front impact severity sensor, remove the air cleaner and air cleaner outlet pipe.
All vehicles
NOTE:
-
Make sure the radiator support and front impact severity sensor mating surfaces are clean and debris free.
-
Note position of locator tab on sensor bracket for installation.
3. Remove the front impact severity sensor bolt
-
Tightening Torque: 12 N.m {1.2 kgf.m, 9 ft.lbf)
4. Disconnect the front impact severity sensor electrical connector and remove the sensor.
5. To install, reverse the removal procedure.
6. Repower the SRS. See DEPOWERING AND REPOWERING.
