B2300 L4-2.3L (2008)
7. Install the foam pad and cushion trim cover to the cushion frame and fasten the J-clips.
8. Install the seat track assembly and the 4 bolts.
-
Tightening Torque: 6 N.m {0.6 kgf.m, 53 in.lbf}
9. Attach the seat cushion trim cover rear J-clip.
10. Install the seat wiring harness retainer clip and attach the seat wiring harness connector to the seat cushion frame.
11. Install the seat backrest.
12. Install the passenger seat into the vehicle.
-
Make sure the safety belts and buckles are accessible to the occupants after installation.
13. Repower the SRS. Do not prove out the SRS at this time. See DEPOWERING AND RE-POWERING.
WARNING:
-
Install a new occupant classification sensor (OCS) system service kit as a complete assembly. Never install only part of the kit
components. Failure to follow this instruction may result in incorrect operation of the OCS system and increases the risk of serious
personal injury or death in a crash.
-
Make sure the front passenger seat repair is complete, the seat and all attached components (head restraint, seat side shield, etc.) are
correctly assembled, and the seat is correctly installed to the vehicle before carrying out the System Reset. Failure to follow these
instructions may result in incorrect operation of the occupant classification sensor (OCS) system and increases the risk of serious
personal injury or death in a crash.
CAUTION:
-
To prevent system failure, it is necessary to carry out the occupant classification sensor (OCS) system reset of the OCS system when a
front passenger seat cushion is disassembled, a new trim cover installed or an OCS system service kit is installed. A scan tool is used to
carry out the OCS system reset command.
-
To prevent system failure, the following precautions must be taken before carrying out the occupant classification sensor (OCS)
system reset:
-
Make sure the OCS system components are connected and no faults are present.
-
Make sure the voltage to the OCS module is above 8.0 volts and less then 18.0 volts
-
Make sure the OCS system is not at a temperature below 6 °C (42 °F) or above 36 °C (97 °F) when initiating the OCS system reset
process. If the vehicle has been exposed to extreme cold or hot temperatures, the vehicle must be exposed and kept at a
temperature within the limits, 6°C to 36 °C (42 °F to 97 °F) for a minimum of 30 minutes.
-
Make sure nothing is present on the passenger seat before carrying out the OCS system reset and nothing is placed on the seat
during the process.
-
Make sure a minimum 8-second time period has passed after cycling the ignition switch ON before the carrying out the OCS
system reset process.
NOTE: If the first attempt to carry out the OCS system reset is unsuccessful, a second attempt must be made. If the second attempt to carry
