B2300 L4-2.3L (2008)
Seat Belt: Removal and Replacement
Safety Belt - Front Center
SAFETY BELT - FRONT CENTER
Safety Belt-Front Center
Removal and Installation
WARNING:
-
After any crash, all of the following safety belt assemblies and attaching hardware must be inspected by an authorized dealer to verify
correct function: Retractors Buckles
-
Belt tension sensor (BTS) (if equipped) Front safety belt buckle support assemblies (slide bar) (if equipped) Safety belt shoulder belt
height adjusters (if equipped)
Child safety seat tether bracket assemblies Automatic locking retractor (ALR) feature for child safety seats (passenger seating positions
only)
If any safety belt assembly is damaged, does not operate correctly or does not pass all of the Functional Tests in the Diagnosis and Testing
portion of this section, a new safety belt assembly must be installed. If any safety belt assembly attaching areas are damaged or distorted,
the sheet metal must be restored to its original structural integrity and new safety belt assembly and attaching hardware must be
installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in
a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or
front outboard passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new
safety belt systems increases the risk of serious personal injury or death in a crash.
1. Position the front seats to allow access to the front center safety belt bolt.
2. For Cab Plus, remove the front center safety belt bolt cover.
3. Remove the front cover safety belt bolt.
-
Tightening Torque: 55 N.m {5.6 kgf.m, 41 ft.lbf}
