B2300 L4-2.3L (2008)
installed. Failure to install new safety belt assemblies and attaching hardware may increase the risk of serious personal injury or death in a crash.
After any crash that results in deployment of the driver and/or front outboard passenger safety belt pretensioners, new driver and/or front outboard
passenger safety belt systems (including retractors, buckles and height adjusters) must be installed. Failure to install new safety belt systems
increases the risk of serious personal injury or death in a crash.
-
To reduce the risk of accidental deployment, do not use any memory saver devices. Failure to follow this instruction may result in serious personal
injury or death.
NOTE:
-
The air bag warning lamp illuminates when the restraints control module (RCM) fuse is removed and the ignition switch is ON. This is normal
operation and does not indicate a SRS fault.
-
The SRS must be fully operational and free of faults before releasing the vehicle to the customer.
-
Repair is made by installing a new part only. If the new part does not correct the condition, install the original part and carry out the diagnostic
procedure again.
All safety belt tractors
NOTE: If the D-ring cover is damaged or does not remain attached, install a new D-ring cover.
1. Remove the D-ring cover.
2. Remove the nut and the D-ring cover.
-
Tightening Torque: 40 N.m {4.1 kgf.m 30 ft.lbf}
Passenger safety belt retractor
3. Depower the SRS. See DEPOWERING AND REPOWERING.
NOTE: Note safety belt routing for installation.
4. Remove the rear door trim panel and disconnect the belt tension sensor electrical connector. See DOOR TRIM PANEL - REAR.
-
Release the wiring harness pin-type retainers.
-
Route out the safety belt webbing.
All safety belt retractors
5. Remove the rear door trim panel. See DOOR TRIM PANEL - REAR.
6. Remove the bolt and safety belt retractor.
-
Tightening Torque: 40 N.m {4.1 kgf.m 30 ft.lbf}
7. To install, reverse the removal procedure.
Passenger safety belt retractor
8. Repower the SRS. See DEPOWERING AND REPOWERING.
All safety belt retractors
9. Check the active restraint system for correct operation.
