B2300 L4-2.3L (2008)
7. Within 2 minutes of the horn sounding, place the activation tool on the RF tire sidewall opposite (180 degrees) from the valve stem and press and
release the test button to train the RF tire pressure sensor.
Note:
^
Do not wait more than 2 minutes between training each sensor or the SJB will time out and the entire procedure must be repeated.
8. Repeat Step 7 for the RR and LR tires.
The procedure is completed after the last tire has been trained. When the training procedure is complete, the message center (if equipped) will
display TIRE TRAINING MODE COMPLETE. For vehicles not equipped with a message center, successful completion of the training procedure
will be verified by turning the ignition switch to the OFF position without the horn sounding. If the horn sounds when the switch is turned to the
OFF position, the training procedure was not successful.
9. Using the Integrated Diagnostic System (IDS) or equivalent tester, locate the updated TPMS sensor IDs trained to the SJB and document them on
the applicable warranty claim.
Note:
^
This step is required to clear DTC C2780, cause the SJB to exit the manufacturing mode and to make sure there are no other concerns with a
newly programmed SJB.
10. If the sensors are being trained due to the installation of a new SJB, clear any DTCs and perform the SJB on-demand self-test.