B2300 L4-2.3L (2008)
1. With the vehicle in neutral, position it on a hoist.
2. Remove the torsion bar cover plate bolts and the torsion bar cover plate.
^
To install, tighten to 55 N-m (5.6 kgf-m, 41 ft-lbf).
Note:
^
Before relieving the torsion bar tension, measure and record the measurement of the torsion bar adjustment bolt. This measurement will be
used as the preset depth for the new torsion bar adjustment bolt during installation.
3. Make preliminary adjustment references.
4. Relieve the torsion bar tension.
1. Position SST 204-185 and 204-204.
2. Tighten SST 204-185 until the torsion bar adjuster lifts off the adjustment bolt.
Caution:
^
The torsion bar adjustment bolt is coated with dry adhesive and must be replaced if it is backed off or removed. Failure to do so
may cause the adjustment bolt to loosen during operation and cause a loss of vehicle alignment.
5. Remove and discard the torsion bar adjustment bolt and support nut.
6. Loosen SST 204-185 until the tension is removed from the torsion bar.
