B2300 L4-2.3L (2008)
Caution:
^
The solenoid clamp must be installed in the TCC and EPC solenoid grooves, shift solenoid pockets and the No. 204 plug.
2. Install the solenoid clamp.
(1) Position the solenoid clamp on the main control valve body.
(2) Install the solenoid clamp bolts.
3. Connect the 6 solenoid electrical connectors.
(1) Connect the (1) SSA, SSB, SSC and SSD electrical connectors.
(2) Connect the (2) torque converter clutch (TCC) solenoid electrical connector.
(3) Connect the (3) electronic pressure control (EPC) solenoid electrical connector.
Caution:
^
Excessive pressure may break the locating pins.
4. Install the main control valve body wire loom.
^
Align the retaining pins to the holes in the solenoid clamps and press in the main control valve body wire harness guide and protector.
5. Install the oil pan and oil strainer.
Note:
^
When filling a dry transmission and converter start with a minimum of 3.7 liters (4 quarts) of clean transmission fluid.
