B2300 L4-2.3L (2008)
Valve Body: Service and Repair
Control Valve Body Removal / Installation
CONTROL VALVE BODY REMOVAL / INSTALLATION
Removal
1. With the vehicle in neutral, position it on a hoist.
Note:
^
If a transmission has been disassembled to replace worn or damaged parts and the valves in the main control valve body stick repeatedly from
foreign material, the torque converter must be removed and cleaned by using a mechanically agitated cleaner, such as the torque
converter/fluid cooler cleaner.
2. Remove the oil pan and oil strainer.
3. Remove the wiring loom protector and guide.
^
Lift up on wire harness guide and protector and disengage the retaining pins from the solenoid clamps.
4. Disconnect the 6 solenoid electrical connectors.
^
Disconnect the (1) SSA, SSB, SSC and SSD electrical connectors.
^
Disconnect the (2) torque converter clutch (TCC) solenoid electrical connector.
^
Disconnect the (3) electronic pressure control (EPC) solenoid electrical connector.
5. Remove the control valve detent bolt (1) and spring (2).
6. Remove the reverse servo assembly.
7. Do not remove the two (gold) bolts specified.
