B2300 L4-2.3L (2008)
Axle Shaft: Testing and Inspection
Axle Flange Circle Runout
AXLE FLANGE CIRCLE RUNOUT
Note:
-
If the axle shaft assembly is removed, check runout of the shaft itself. The forged (unmachined) part of the shaft is allowed to have as much as
3.0 mm (0.120 inch) runout. This alone will not cause a vibration condition.
1. Position the Dial Indicator with Bracketry on the wheel hub or axle flange face, as close to the outer edge as possible. Zero the indicator to allow
the pointer to deflect either way.
2. Rotate the hub or flange one full turn and note the maximum and minimum readings. The difference between the maximum and minimum readings
will be the total wheel hub or axle flange bolt pattern runout. The runout must not exceed 0.38 mm (0.015 inch).
