B2300 L4-2.3L (2008)
Axle Shaft: Testing and Inspection
Axle Shaft Pilot Runout Rear
AXLE SHAFT PILOT RUNOUT REAR
1. Position the Dial Indicator with Bracketry with Clutch Housing Alignment Adapter SST (308-021) to the pilot, as close to the hub or axle flange
face as possible. Zero the indicator to allow the pointer to deflect either way.
2. Rotate the hub or flange one full turn and note the maximum and minimum readings. The difference between the maximum and minimum readings
will be the total pilot runout. Pilot runout must not exceed 0.15 mm (0.006 inch).
