B2300 L4-2.3L (2008)
Flywheel: Service and Repair
Flywheel Housing to Block Dowel Removal / Installation
FLYWHEEL HOUSING TO BLOCK DOWEL REMOVAL / INSTALLATION
Note:
^
Take care not to damage the flywheel housing-to-block dowel holes or the surface areas around the flywheel housing-to-block dowel hole
during removal.
1. Remove the flywheel housing-to-block dowels using a drift pin where the flywheel housing-to-block dowel is installed in an open hole and a pair
of locking pliers where the flywheel housing-to-block dowel is installed in a blind hole.
Note:
^
Care should be taken to drive the flywheel housing-to-block dowel squarely into place until it is fully seated without damaging the surrounding
surface areas.
2. Install all flywheel housing-to-block dowels by driving them into place using a brass or plastic mallet.