B2300 L4-2.3L VIN D (2004)
Wheel Speed Sensor: Service and Repair
Speed Sensor Rear Axle
SPEED SENSOR REAR AXLE REMOVAL / INSTALLATION
1. Raise and support the vehicle.
2. Disconnect the rear axle speed sensor connector (1).
3. Remove the bolt (2).
4. Remove the rear axle speed sensor (3).
Note: Inspect the antilock brake sensor O-ring for damage; lightly lubricate O-ring with rear axle lubricant
Caution: Before removing the rear axle speed sensor, clean any dirt around the sensor to prevent the dirt from contaminating the rear axle fluid.
5. Install in reverse order of removal.
Tightening torque 31 - 40 Nm (3.5 - 4.1 kgf-cm, 25 - 29 ft. lbs.)