B2300 L4-2.3L VIN D (2004)
Electronic Brake Control Module: Service and Repair
ABS CONTROL MODULE REMOVAL / INSTALLATION
1. Remove the hydraulic control unit.
Note:
^
The ABS module cannot be repaired, install a new ABS module
2. Remove the bolts
Caution:
^
When the ABS module separated from the HCU, the motor terminals and the valve stems will be exposed. Protect the terminals and the valve
stems from damage.
3. Remove the ABS module from the HCU
Caution:
^
A new seal kit must be used when in stalling the ABS module. The old seals must be discarded as they may cause a leak between the ABS
module and the HCU.
Note:
^
The O-ring seals must be installed to the valve flange. Make sure there is no twist to the O-ring seal when installed.
4. Discard the O-ring seals and install new ones (one seal per each valve stem).
Note:
^
Clean the groove of the ABS module before installing a new seal.