B2300 L4-2.3L VIN D (2004)
3. Release the pin-type retainer and disconnect the electrical connector.
12. Release the lower clockspring retaining clip
13. Remove the clockspring.
1. Release the remaining two clockspring retaining clips.
2. Remove the clockspring.
Installation
Vehicles receiving a new clockspring
NOTE: A new clockspring is supplied in a centralized position and held there with a key.
1. Remove the key from the clockspring, holding the rotor in its centralized position.
1. Do not allow the clockspring rotor to turn.
Vehicles needing clockspring recentering
WARNING: Incorrect centralization may result in premature component failure. If in doubt when centralizing the clockspring, repeat the
centralizing procedure. Failure to follow this instruction may result in personal injury.
CAUTION: Make sure the road wheels are in the straight-ahead position.
NOTE: If a clockspring has rotated out of center, follow through with this step.
