B2300 L4-2.3L VIN D (2004)
^
Please be aware that PCM calibration part numbers and file names listed in any Service Bulletin may change due to future releases of WDS
software, and additional revisions made to those calibrations for service related concerns.
^
When reprogramming a PCM, WDS will always display the "latest" calibration P/N available for that vehicle. If any calibration has been
revised/updated to contain new information for a new service concern/issue, it will also contain all previously released calibrations.
^
When performing this procedure, if the WDS PTU is not docked and connected to 115V-120V, we recommend that a battery charger be
installed on the vehicle battery and turned ON to a maximum charge of no more than 20 AMPS to keep the vehicle battery up to capacity.
If you exceed 20 AMPS, it will damage the WDS PTU.
^
Install an "Authorized Modification" label (P/N 9999-95-AMDC-97) with the new calibration information next to the Emission Control
sticker on the radiator support. The "Authorized Modification" label will inform technicians of the PCM calibration change if future repairs
are necessary.
2.
Afier performing the PCM reprogramming procedure, verify the repair by starting the engine and making sure there are no MIL illumination or
abnormal warning lights present.
NOTE:
After PCM reprogramming, it is no longer necessary to road test the vehicle to "relearn" KAM (Keep Alive Memory).
CALIBRATION INFORMATION
NOTE:
The PCM Calibration Part Numbers listed above are provided for PCM reprogramming purposes only. These are not necessarily the same Mazda
part numbers used to order an actual PCM through the Mazda Parts System. It is not necessary to order a PCM as part of this repair procedure.
PART(S) INFORMATION
