B2300 L4-2.3L VIN D (2004)
18. Inspect the parking pawl, parking pawl return spring and the parking pawl shaft.
1) Replace if required.
Installation Note
Caution:
^
Make sure the parking lever actuating rod is correctly seated into the case parking rod guide cup. Verify that the output shaft is locked in the
PARK position.
1. Align the flats of the manual valve inner lever with the flats on the manual control lever shaft. Install the manual valve inner lever and parking
lever actuating rod onto the manual control lever shaft.
Caution:
^
Do not bend the manual valve inner lever pin.
2. Install the manual valve inner lever nut.
3. Install new extension housing gasket and install the extension housing.
4. If equipped, install the transfer case.
Note:
^
Align the drive shaft with the marks made during removal to ensure correct balance.
5. Install the rear propeller shaft bolts.
