B2300 Regular Cab 2WD L4-2.3L VIN A (1997)
4. Install the engine oil pan.
Tightening torque: 14-16 Nm (124-141 inch lbs.)
NOTE: The transmission bolts to the engine and oil pan when installed. It is necessary to measure the gap between the surface of the rear face of
the oil pan (at spacer locations) and the rear face of the engine block so that it extends over one of the oil pan/ transmission bolt mounting pads.
5. With the oil pan installed on the engine, position a straightedge flat on the rear of the engine block so that it extends over one of the oil
pan/transmission bolt mounting pads.
6. Measure the gap between the mounting pad and the straightedge using a feeler gauge. Repeat the procedure for the other mounting pad. Select
spacers of the required thickness from the chart.
CAUTION: Failure to measure the required spacer thickness can result in insufficient, or excessive clearance between the engine oil pan and the
transmission, when installed in the vehicle. This can result in oil pan damage, and/or an oil leak.
7. Install the selected spacers to the mounting pads on the rear of the oil pan before bolting the engine and transmission together.
8. Fill with specified amount and type of engine oil.
9. Start the engine and check for leaks.
10. Check the oil level and add oil if necessary.
