B2300 Regular Cab 2WD L4-2.3L VIN A (1997)
Ignition Coil: Service and Repair
Removal/Installation
1. Disconnect the negative battery cable.
2. Remove in the order shown in the figure, referring to REMOVAL NOTE.
3. Install in the reverse order of removal, referring to INSTALLATION NOTE.
Removal Note
1. Disconnect the high-tension leads from the ignition coils by squeezing the locking tabs on the lead by hand. Use a twisting and pulling motion to
free the boot from terminal.
Do not pull on the wire.
2. Disconnect the harness connector from the ignition coil.
3. Remove the screws and remove coil.
NOTE
^
On vehicles equipped with A/C, remove the air conditioning tube-to-plenum bolt and move the tube enough to gain access to the upper coil
pack bolts.
3. Remove the coil bolts and remove the coil.
Installation note
Ignition coil assembly
1. Mount the ignition coil to its bracket and install screws.
Tightening torque:
5 - 7 N.m (51 - 71 kgf.cm, 44 - 66 in.lbf)
2. Reconnect engine harness electrical connector to the ignition coil.
3. Insert each lead on the proper terminal of the ignition coil. Make sure that the coil boots are fully seated and both locking tabs are engaged.
