B2300 Regular Cab 2WD L4-2.3L VIN A (1997)
NOTE: Make sure the ball joint seals are in place.
2. Install the camber/caster adjuster into the same position it was removed from.
3. Tighten the nut to 120 - 180 Nm (89 - 133 ft. lbs.).
4. Tighten the nut to align the next slot with the hole in the ball joint.
5. Install a new cotter pin.
6. Tighten the bolt to 68 - 92 Nm (50 - 68 ft. lbs.).
Tie-Rod End (1)
1. Install the tie-rod end into the knuckle.
2. Tighten the nut to 70 - 100 Nm (52 - 73 ft. lbs.).
3. Tighten the nut to align the next slot with the hole in the tie-rod end.
4. Install a new cotter pin.
