B2300 Regular Cab 2WD L4-2.3L VIN A (1997)
10. Remove the control valve body as an assembly.
INSTALLATION
1. Install the alignment pins into the case in the positions shown.
2. Install a new gasket and separator.
NOTE:
^
Use petroleum jelly to hold the gasket in place.
^
Make sure the holes in the gasket line up with the holes in the control valve body.
3. Install the control valve body assembly.
a. Position the assembly.
b. Align the manual valve with the inner manual valve lever pin as shown.
c. Install the valve body bolts finger-tight.
d. Remove the alignment pins.
