B2300 SE Regular Cab 2WD L4-2.3L VIN A (1997)
Balls (4)
Rotate the input shaft from stop to stop until all the balls fall from the piston into a container.
Race Locknut Set Screw (5)
Install the valve body assembly in the SST and loosen the race locknut set screw.
Worm Bearing Race Locknut (6)
Remove the worm bearing race locknut using Adjuster and Locknut Wrench T66P-3553-B and Spacer Valve Housing To Piston T66P-3553-C, or
equivalents.
Worm And Valve Sleeve Assembly (Valve Sleeve Seals) (7)
Remove the valve sleeve seals from the sleeve by inserting the blade of a small pocket knife under them and cutting them off.
CAUTION: Do not scratch the valve sleeve.
ASSEMBLY
1. Assemble in the reverse order of disassembly, referring to the following:
Worm And Valve Sleeve Assembly (7)
1. Mount the worm end of the worm and valve sleeve assembly into a soft-jawed vise.
