B2300 SE Regular Cab 2WD L4-2.3L VIN A (1997)
7. Install a new gasket and the reverse piston cover and tighten in order shown to 12 - 14 Nm (106 - 124 inch lbs.).
8. Connect the solenoid connectors to the solenoids.
NOTE: The wiring guide snaps into place on the solenoid retainers.
9. Install the wiring loom protector and guide. Align the pins in the holes of the solenoid brackets and gently push down.
CAUTION: Excessive pressure may break the locating pins
10. Test the solenoid valves.
11. Install new O-rings on the oil strainer.
12. Apply petroleum jelly to the O-rings.
13. Install the oil strainer and tighten to 8 - 11 Nm (71 - 97 inch lbs.).
