B2300 SE Regular Cab 2WD L4-2.3L VIN D (2001)
Seat Cushion: Service and Repair
Removal and Installation
Removal Note:
WARNING: Always wear safety glasses when repairing an air bag supplemental restraint system (SRS) vehicle and when handling an air bag
module. This will reduce the risk of injury in the event of an accidental deployment.
WARNING: After deployment, the air bag surface can contain deposits of sodium hydroxide, a product of the gas generant combustion that is
irritating to the skin. Wash your hands with soap and water afterwards.
WARNING: Never probe the connectors on the air bag module. Doing so can result in air bag deployment, which can result in personal injury.
Vehicles with safety belt buckle pretensioners
1. Prepare the vehicle for front seat cushion removal.
WARNING: To avoid accidental deployment and possible personal injury, the backup power supply must be depleted before repairing
or replacing any front or side air bag supplemental restraint system (SRS) components and before servicing, replacing, adjusting or
striking components near the front or side air bag sensors, such as doors, instrument panel, console, door latches, strikers, seats and hood
latches.
To deplete the backup power supply energy, disconnect the negative battery cable and wait at least one minute. Be sure to disconnect auxiliary
batteries and power supplies (if equipped).
1. Disconnect the negative battery cable.
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the
supplemental restraint system (SRS) deactivation/reactivation procedure.
2. Deactivate the supplemental restraint system (SRS).
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.
3. Remove the affected seat.
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the safety
belt buckle and pretensioner removal and installation procedure.
4. Remove the safety belt buckle and pretensioner.
Vehicles without safety belt buckle pretensioners
WARNING: To reduce the risk of serious personal injury, read and follow all warnings, cautions, notes, and instructions in the seat
removal and installation procedure.
2. Remove the affected seat.
Vehicles with 60 percent bench seat
3. Remove the seat armrest.
All vehicles
4. Remove the center safety belt buckle through the opening in the front seat cushion.
5. Remove the front seat backrest.
6. Remove the seat track.
Installation Note:
WARNING: To reduce the risk of serious personal injury, read and follow warnings, cautions, and notes at the beginning of the removal
procedure.
All vehicles
1. Install the seat track.
2. Install the front seat backrest.
