B2300 SE Regular Cab 2WD L4-2.3L VIN D (2001)
11. Install an M6 bolt in the crankshaft pulley. Tighten the crankshaft retaining bolt in two stages.
^
Stage 1: Tighten to 40 Nm (30 ft. lbs.).
^
Stage 2: Rotate the bolt an additional 90 degrees.
12. Install the crankshaft position sensor, do not tighten the bolts at this time.
13. Adjust the crankshaft position sensor with the Alignment Tool, and tighten the mounting bolts.
14. Connect the crankshaft position sensor electrical connector.
