B2500 SE Regular Cab 2WD L4-2.5L VIN C (1998)
Valve Cover: Service and Repair
REMOVAL AND INSTALLATION
1. Disconnect the battery ground cable.
2. Disconnect the Intake Air Temperature (IAT) sensor.
3. Remove the air cleaner outlet tube; refer to Air Cleaner Outlet Tube Removal/Installation.
4. Remove the accelerator control splash shield.
5. Remove the accelerator cable; refer to Accelerator Cable Removal/Installation.
6. Disconnect the crankcase vent from the valve cover.
7. Disconnect the fuel charging wiring from the Idle Air Control (IAC) valve and the Throttle Position (TP) sensor.